Reset samsung printer ML-2240 use Jumper
ML2240+2 300x287 Reset samsung printer ML 2240 use JumperTips for this time is about how to reset samsung printer ML-2240 is already showing numbers above 1800 on the counter page. Samsung  printer ML-2240 need to be reset so the printer does not blink, along with its flashing red lights on the printer. Indicator A red light indicates that the toner has run out. Although we have refill toner, but the red light can not be lost so the printer can not be used. In order for the Samsung printer ML-2240 can be used again, then we should reset the page counter manually or by installing a new chip. For how to manually reset samsung printer Ml-2240 using the jumper will be explained here.
Before performing the manual reset, check the OS of Samsung printer  ML2240 which will be reset.
  1. Turn on the printer, and wait for the printer calibration process
  2. do test print by pressing the Resume button for 3 seconds then Release and printer do a test print.
  3. After the test print is complete, note the OS Version of the test results of your printer.
Not all OS Samsung ML 2240 printer can we reset manually using a jumper.
Type OS Version Samsung ML-2240 which can be reset are:
  • OS number
  • OS number
  • OS number
  • OS number
  • OS number
  • OS number
Samsung Printer OS type that can not be reset manually:
  • OS number
  • OS number
Reset procedure Samsung printer ML-2240 manually is as follows:
A. The equipment used
  • Screwdriver plus (+), and a screwdriver minus (-)
  • Cable or small wire to jumper

B. How to reset Samsung ML-2240 printer

  1. Unplug all cables printer (the printer power cable and data cable printer), and make sure the printer is turned OFF switches
  2. Remove the two bolts that are on the left and right at the back of the printer using a screwdriver plus (+)
  3. After both bolts removed, and the socket lock is opened, slide the cover to the side slowly.
  4. Remove the cooling fan attached to the cover
  5. It will be seen two engines Samsung ML-2240 printer, the machine power supply and motherboard.
  6. Find and watch IC EEPROM 8 feet that attach to the mainboard printer Samsung ML-2240, ie the number 93C66WP ic U6.
  7. After the IC U6 is found, install and connect a jumper or a small wire to the ic leg 1 and 4
  8. After leg 1 and 4 on the IC is connected, plug the power cable, and turn on the printer.
  9. Wait a few moments until the printer has finished calibrating and lights show green
  10. After the green light, turn off the printer, then remove the cable or wire attached to the legs 1 and 4 IC EEPROM 93C66WP
  11. Close the back cover of the printer and do not forget to plug the two bolts that screw removed earlier.
After all these steps done, reset  Samsung printer ML-2240 is completed, the printer is ready for use again.

Bagikan artikel ini

Posted by Indographia 2 Comments , ,


Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>